| Author |
Message |
|
|
 Posted On: Thu Mar 18,2010 2:18 am |
|
|
| The 1/10 scale, electric, r / c controlled, almost willing to run HPI On-Path Sprint 2 Drift Car using the Toyota Trueno Body. _
FEATURES: Chassis: 3/16" (4mm) thick shot cast nylon Drive: Four controls double belt drive Ball Bearings: Complete set included Shocks: Oil-filled, plastic bodied, with special springs for drifting Differentials: Planetary gear Transmission: Single speed, handles altered motors 10 turns and above Tires: Difficult compound drift variety A, 1" (26mm) wide, 2.5" (65mm) outer diameter Trolley wheels: Officially registered TE37 Rays/Volk design 5-spoke chrome plated, outer diameter 1.9" (48mm), width 1" (26mm), 3mm offset in front and 6mm balanced out in rear for wide look seen on full-size drift cars Pinion Gear: 48 pitch steel Spur Gear: 48 pitch, 87 tooth, composite construction Bumpers: Front, foam Suspension: Entirely flexible Ackerman: Adaptable, Ackerman identifies the impact belonging to the inside entrance wheel turning faster as opposed to outer front wheel throughout turns Caster: Adjustable, caster/toe-in looks at the angle from the front suspension when viewed in the side with the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bell-crank type with servo saver
hpi sprint rtr |
|
|
